spur gears

Articles About spur gears


Articles are sorted by RELEVANCE. Sort by Date.

1 Crowning Spur Teeth - Ask the Expert - December 2013 PTE (December 2013)

When designing spur teeth, is there a formula/guideline/design guide for determining the amount of crowning?

2 Determination of Load Distributions on Double Helical-Geared Planetary Gearboxes (June 2017)

Standardized calculation methods such as ISO 6336 and DIN 3990 already exist to determine the load distributions on gears inside a planetary gearbox, but by their very universal nature, these methods offer varying results depending on the gearbox design. Double helical gears, in particular, can benefit from more specific, complex algorithms to reach a maximum level of efficiency. Double helical gears interact with the rest of the gearbox differently than helical or spur gears, and thus benefit from different analytical models outside the standardized methods. The present research project describes the algorithm to determine the load distribution of planetary gearboxes with double helical gears.

3 Determining Diametral Pitch, Center Distance (October 2016)

I need help determining the diametral pitch needed to achieve the closest center-to-center distance for 2 spur gears. The 1st gear is a 34-tooth and the 2nd gear is a 28-tooth. The center-to-center distance between the gears needs to be as close to 2 1⁄8" as possible.

4 Preventing Roller Bearing Failure (December 2015)

I’m building a custom gearbox with 7075 T-6 spur gears, and I’m concerned that aluminum flakes will enter the races on the roller bearings (SKF 2307) and cause premature failure. So my question is — should I place an oil seal on the shaft first to protect the bearing — or is this an unfounded concern and I should mount the seal in the typical manner outside the bearing? Or both? Or go with a sealed bearing? I’m confused and could use your expertise, please.

5 Specifying a Gear - Ask the Expert (February 2014)

A reader asks what are the required parameters to properly specify a gear.

News Items About spur gears

1 Worm and Spur Gears, English and Metric (May 30, 2007)
SDP/SI is an ISO 9001 manufacturer of over 13,627 spur gears, plastic gears, helical gears, bevel gears, worm gears, precision gears, int...

2 Spur Gears, Metric Gears, Gears with Internal Shafts (July 12, 2007)
These 20 degree Pressure Angle pinion shafts are made of S45C (AISI 1045) steel and feature induction hardened and ground teeth which are...