We use cookies to provide you with a better experience. By continuing to browse the site you are agreeing to our use of cookies in accordance with our Privacy Policy.
I'm not able to get a good connection
between the pulley and shaft in my drive
assembly. Could you explain the various
ways of connecting a pulley to a shaft to
prevent the pulley from slipping?
It's not a show title that rolls off the tongue, but the Industrial Automation North America and MDA NA @IMTS 2014 show nevertheless may well be one to remember.
Dovetails, gears and splines have been widely used in aero engines where fretting is an important failure mode due to loading variation and vibration during extended service. Failure caused by fretting fatigue becomes a prominent issue when service time continues beyond 4,000 hours. In some cases, microslip at the edge of a contact zone can reduce the life by as much as 40–60 percent.