According to Rose+Krieger, a new generation of RK DuoLine linear units, supplied with a spindle or timing belt, will bring greater flexibility to automation. Optional coupling and motor adapters can be attached to all four hollow shaft outputs on the idler unit. Not only does this simplify positioning, customers can also configure and adjust the axial motor themselves. The DuoLine with spindle drive is fitted with a newly developed spindle support for increased rotational speeds. A vmax of two m/s with stroke lengths of around five meters is possible. All DuoLine variants are magnetically sealed with a steel band increasing the protection rating to IP40. The enclosed ball rail system also provides an efficiency rating above 85 percent on the spindle variant and brings the no-load torque for the timing belt variant down to 2.5 Nm. The variants also share common features in terms of the table installation options. The BLOCAN profile slots have T-rails with tapped holes to simplify the attachment of loads and provide the greatest possible flexibility. The central lubricator on the table that supplies grease to the guide system and spindles depending on the type reduces maintenance. The DuoLine generation begins with the 160 x 100 size corresponding to the length of the edge on the guide profile in mm. The manufacturer offers a specific service for selecting the right motor specification.